DESIGN AND FABRICATION OF A METAL BOOKSHELF
Sold By: Joe Project Store | Item Type: Project Material | Report this? | Attributes: 65 pages | 1-5 chapters | Amount: ₦5,000 | Marked useful: 4,662 times
Delivery: Within 24 hoursABSTRACT
Knowledge could only be obtained successfully by the use of book for research but unfortunately because of hard times, books have become very expensive. This is called for presentation of books already purchased whether in the library or on the household so that it can be used by the future generation. There could only be done by stacking books systematically on a book rack where by it can be file from rats and other insects that could destroy books.
Our aim contribution to this development is the design and manufacture of a book rack that will be economically cheap and at the same time meet up its demands.
Book racks could be made with metals or wood. Again they could be attacked to the wall or they could be made standby on the floor. Our book rack will be of metal and made to stand on the floor.
TABLE OF CONTENTS
Title page
Letter of approval
Release
Signature
Approval
Dedication
Acknowledge
Abstract
CHAPTER ONE
1.1 Introduction
1.2 Description Of The Bookshelf
CHAPTER TWO
2.1 Mode Of Operation
2.2 Material Selection
CHAPTER THREE
3.1 Design
3.2 Design Analysis
3.3 Capacity Of The Bookshelf
3.4 Design Experiments
3.5 Construction
3.6 Sequence Of Operation
CHAPTER FOUR
4.1 Cost Of Analysis
CHAPTER FIVE
5.1 Conclusion
5.2 Recommendation
5.3 Reference
This material content is developed to serve as a GUIDE for students to conduct academic research
Find What You Want By Category:
Delivery: Within 24 hours
Advertise Here
For advertisement, call 08168958821
Not what you were looking for? Perform a search
What's your project topic?
Comment on Facebook:
Related Project Materials
- 1.
INVESTIGATION OF THE EFFECT OF MOULDING SAND (NATURAL & SYNTHETIC) ON CASTING OF FLANGE USING ALUMIN...
ABSTRACT This study tend to investigate the effect of synthetic and natural moulding sand on casting of flange like component. In this study FUTA lo...More »
Item Type: Project Material | 50 pages | 13,551 engagements |
- 2.
DESIGN AND FABRICATION OF AN OFFICE FILE CABINET
ABSTRACT This project covers the design and fabrication of an office file cabinet. The cabinet is to keep and secure files and document for future rec...More »
Item Type: Project Material | 50 pages | 12,329 engagements |
- 3.
DESIGN AND FABRICATION OF MECHANCIAL LAWN MOWER
ABSTRACT Mechanical engineering department of the named institute has many non operational machines sequel to this fact mainten...More »
Item Type: Project Material | 50 pages | 10,657 engagements |
- 4.
THE DESIGN AND CONSTRUCTION OF HOT PRINTING MACHINE
ABSTRACT Parameters on which clear prints depends were comprehensively investigated. The study revealed that clear print dep...More »
Item Type: Project Material | 50 pages | 8,507 engagements |
- 5.
THE CONSTRUCTION AND FABRICATION OF METAL BOOKSHEET
ABSTRACT In our society today reading and writing has taken its roll as a way of measuring human knowledge. Knowledge could only be obtain succe...More »
Item Type: Project Material | 50 pages | 8,206 engagements |
- 6.
REPAIR OF AIR CONDITIONER IN MECHANICAL ENGINEERING DEPARTMENT
CHAPTER ONE 1.1 AIR CONDITIONER Indoor climate, once adjusted to human need only by opening of heating in winter and by open...More »
Item Type: Project Material | 50 pages | 8,310 engagements |